|
Standard Features:
Explosion Relief Vent Panels:
Explosion-relief vent panels designed to release at a maximum internal pressure of 20 PSF. This system complies with Factory Mutual requirements for storage of Class IA and dispensing of Class IA and IB liquids.
Interior Lighting:
Explosion proof incandescent ceiling mounted with guard, glass globe and 150 Watt lamp.
Walls:
3-5/8" wide steel studs spaced 12" covered with two layers of 5/8" type exterior gypsum wallboard each side. Skinned with ASTM A591, 18-gauge steel white epoxy coated panels.
Roof/Ceiling:
Consists of 5/8" plywood covered with one-piece single ply membrane that features a 20-year warranty supported with 18-gauge steel joists that are 7" deep and spaced at 12" on center. Two layers of 5/8" gypsum board are attached and then covered with 18-gauge white epoxy coated steel panels.
Steel Grating:
1" bars painted black.
Floor Support:
6" steel beams run the entire length of the housing and are positioned for holding heavy capacities.
Ventilation System:
400 CFM for optimum air exchange rating.Ramp:
Access ramp fabricated from heavy-duty plate steel. One-piece fabrication without welding points providing non-corrosive, long life finish. 6:1 ratio run to rise 12" H x 70-1/2" L x 33" W. Painted white polyurethane with 2" wide grip tape at 4" intervals.
Heaters, Convection:
Single phase, 208-volt. Designed for hazardous locations, Class 1, Division 1, Groups C and D environments. Custom sizes for each specific application.
Air Conditioning Units:
Class 1, Division 2 recirculating wall unit designed for specific application.
|
|
Control Panel:
NEMA 4 water/oil tight enclosure incorporates voltage per customer requirements, UL listed system, fuse block, and operating switches.
Water Sprinkler System:
Featuring sprinkler heads and exterior hook-ups connecting adapter in accordance with NFPA-13.
Sump Construction:
Liquid tight heavy gauge sheet steel supported by exterior welded steel risers to allow for under sump leak inspection.
Extra Large Spill Containment:
Sump holds 30% of locker's liquid storage capacity surpassing regulatory and FM requirements.
Surfaces Protected:
Exterior - High-quality weather-resistant coating in neutral white, satin-gloss finish.
Interior - Chemical-resistant coating in white, semi-gloss finish.
Static Electricity Bonding/Grounding System:
Interior wall-mounted grounding lugs and exterior grounding connection, separate 8-ft. grounding rod and cable for customer installation.
Options:
Fire Protection:
Dry Chemical Systems. A pre-engineered industrial Dry Chemical fire extinguisher system that incorporates a network of piping and discharge nozzles as defined by NFPA-17. A "Total Flooding" system is used whereby the Dry Chemical is discharged into the building enclosure. This system includes an agent storage tank, actuator, quick release, flow nozzles, 212° F. fusible link, pull-station, and alarm. UL listed and FM approval.
Fiberglass Floor Grating:
1" thick, fire retardant, corrosion and UV resistant, permanently bonded quartz grit for anit-skid surface.
Liquid Level Detection System with Alarm:
Features an explosion-proof float switch, vertically mounted microswitch, 10-amp rating, resistive 3-amp, inductive 30-volts.
Building Code Compliance:
For compliance with International, Uniform, National and Standard Building codes:
-Additional 6" of sump height to contain 20 minutes of sprinkler water plus single largest container.
-Totally non-combustible ceiling in addition to fire rating.
- Adaptions to accept ducting at explosion relief panels. This allows for easy vent ducting to outside. Additional duct panels not included.
|
